|
||||||||||||||
|
||||||||||||||
| Dimension tolerances |  | ||
| Post Reply | Forum | ||
| Posted by: gdaykens ® 10/11/2007, 08:17:51 Author Profile eMail author Edit |
I have a hole callout symbol in solidworks that I would like to change the precision level of the hole diameter differently than the precision level of hole depth. For examble, I want the hole diameter to a precision of 4 decimal places, but the depth isn't as important, and 2 decimal places is adequate. Anyone know how to do that? |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | Previous | Next | Current page |
| Replies to this message |
| Re: Dimension tolerances |  | | |
| Re: Dimension tolerances -- gdaykens | Post Reply | Top of thread | Forum |
| Posted by: markkot ® 10/11/2007, 08:47:19 Author Profile eMail author Edit |
1st select the dimension
2nd select the callout value (Right under the Green Checkmark) Select the i.e Counterbore depth 3rd select the precision that you desire
|
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | Previous | | Current page |
