hole prompt
	Post Reply		Forum

Posted by: CCR5600Design ® 10/26/2007, 15:52:30 Author Profile eMail author Edit

Is it just me, or is there no way to prompt the "hole options" box to pop up when I pick the hole feature in the sheetmetal or part environment? I have tried, with no success, to figure out how to toggle this on so I don't have to repeatedly pull it up manually for entering the geometry for a desired hole. Anyone had any experience with this? Ron "What we need are more people who specialize in the impossible." - Theodore Roethke

Post Reply Tell a Friend (must be logged in) Alert Admin About Post

View All

Previous | Next | Current page

Replies to this message

Re: hole prompt
Re: hole prompt -- CCR5600Design	Post Reply	Top of thread	Forum

Posted by: RT41 ® 01/17/2008, 10:35:48 Author Profile eMail author Edit

I know, this is bizzare, but you can do it in 2 mouse click, click on the feature (on the part or on the pathfinder), then you'll see in the ribbon bar appearing 5 icon, the left one is edit definition, you click then you'll see the hole option icon appearing at the same place

Post Reply Tell a Friend (must be logged in) Alert Admin About Post

Where am I? Original Top of thread

Previous |   | Current page