Engineers Edge
Pipe in use lateral movement Question
Post Reply   Forum
Posted by: BCH ®

04/29/2008, 19:16:46
Author Profile
eMail author
Edit

I am in the process of developing a design for a pipe run in a product pile that will slump up to 36 inches latterly with limited axial and rotational movement. This will be a high temperature environment of 900+ degrees F. Any ideas out there?????






Modified by BCH at Tue, Apr 29, 2008, 19:18:54


Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post		 View All   Previous | Next | Current page

Replies to this message

: Pipe in use lateral movement
: Pipe in use lateral movement -- BCH Post Reply Top of thread Forum
Posted by: hardcoreengineer ®

05/02/2008, 23:59:34
Author Profile
eMail author
Edit

depending on the size of the material that you are attemting to move i would say an auger might work if that is within your allowable movment







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post		 Where am I? Original Top of thread Previous |   | Current page
: Pipe in use lateral movement
: Pipe in use lateral movement -- BCH Post Reply Top of thread Forum
Posted by: Kelly Bramble ®

04/29/2008, 20:07:51
Author Profile
eMail author
Edit

How long is the run? Are you implying that you will not have any supports?







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post		 Where am I? Original Top of thread Previous | Next | Current page
: : Pipe in use lateral movement
: : Pipe in use lateral movement -- Kelly Bramble Post Reply Top of thread Forum
Posted by: BCH ®

04/30/2008, 09:40:27
Author Profile
eMail author
Edit

The run is 12 feet, it will be unsupported in that run, the pipe it is attached to will be supported. This is a movement that will take place as degradation in the product takes place over time.







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post		 Where am I? Original Top of thread Previous |   | Current page