|
|
|
||
| Concentricity Tolerance | |||
| Post Reply | Forum | ||
|
Posted by: Ron A. 04/11/2003, 17:44:35 Edit |
Is it correct (or practical) to put a Concentricity tolerance on a pitch diameter for a bolt circle?I saw this on a drawing, and it struck me funny, especially since there was no position tolerance on the bolt holes.How would it be measured?Thanks!
|
| Post Reply | Recommend | Alert | Rate | View All | | Next | |
| Replies to this message |
|
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer