Aluminum Info
	Post Reply		Engineering Forum

Posted by: CFS Ind ® 10/27/2009, 14:14:28 Author Profile eMail author Edit

Would like to build a pre-heat de-solder fixture using 6061 aluminum or better. Heat range is 500-650 deg F. Anyone have experience with a preferable alternative? Looking for better wear resistance and resistance to flux/solder adhesion. Will appreciate any thoughts.

Post Reply Tell a Friend (must be logged in) Alert Admin About Post

View All

Previous | Next |

Replies to this message

: Aluminum Info
: Aluminum Info -- CFS Ind	Post Reply	Top of thread	Engineering Forum

Posted by: Marky ® 10/27/2009, 14:28:21 Author Profile eMail author Edit

Hi and welcome to the forum....can you post a model or a sketch?

Post Reply Tell a Friend (must be logged in) Alert Admin About Post

Where am I? Original Top of thread

Previous | Next |

: : Aluminum Info
: : Aluminum Info -- Marky	Post Reply	Top of thread	Engineering Forum

Posted by: CFS Ind ® 10/27/2009, 16:24:16 Author Profile eMail author Edit

Dimensions are inches

Post Reply Tell a Friend (must be logged in) Alert Admin About Post

Where am I? Original Top of thread

Previous |   |