WATER FLOW RATES
	Post Reply		Forum

Posted by: ascomm ® 02/26/2004, 13:38:31 Author Profile Mail author Edit

Recently had a 4 inch pipe break.  Lucky the fitting shattered from the freeze.  The Municipality stated that we have used approximately 60800 Cubic Feet or 455392 Gallons of water.  At a pressure of 100 psig, I need to quantifiable ascertain via Excel Spreadsheet the amount of time it has taken to reach the loss of water.   Ascomm ascomm

Replies to this message

Equations and Design Data
Re: WATER FLOW RATES -- ascomm	Post Reply	Top of thread	Forum

Posted by: Administrator ® 03/07/2004, 19:06:50 Author Profile Mail author Edit

Well,  no calculators yet but, check out the following new and old pages (calculators will follow soon). Fluid Pressure Loss Along Pipe Length of Uniform Diameter and Hydraulic, General Fluid Characteristic Chart Fluid Flow - Table of Contents Moody Chart Pipe Schedules Pipe - Steel Burst Pressure Chart Pipe Max Flow Rate Fluids Flow, Aerodynamics Pipe Strength Relationship Between Displacement and Torque of a Hydraulic Motor Burst Pressure of Pipe or Tube Heat Radiating Capacity of a Steel Reservoir Effective Force of a Cylinder at an Angle to Direction of the Load Travel Side Load on Pump or Motor Shaft Hydraulic Cylinder Piston Velocity Heat Equivalent of Fluid Power Boyles Law for Behavior of Gas Charles Law for Bahavior of Gases Velocity of Oil Flow in Pipe

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread

Re: Hey Kelly
Re: WATER FLOW RATES -- ascomm	Post Reply	Top of thread	Forum

Posted by: RandyKimball ® 02/26/2004, 20:26:14 Author Profile Mail author Edit

Here is a good calculator for the site. Fluid flow through a port size, at a pressure, at some standard fluids with provided viscosities or a known visosity, over time. .. [perhaps at an optional temperature coeificient] ... knowing any two and/or temperature Ascomm .. I'd expect a calculator any day, as usual, Kelly will likely do us proud! -randy- The worst suggestion of you lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them. Modified by RandyKimball at Thu, Feb 26, 2004, 20:37:08

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread

| |

Re: Calculator Suggestion
Re: Re: Hey Kelly -- RandyKimball	Post Reply	Top of thread	Forum

Posted by: Administrator ® 02/29/2004, 19:37:16 Author Profile Mail author Edit

I might need a week a so, I'll have do a liitle research to come up with a practical application equation. Great suggestion. Modified by Administrator at Sun, Mar 07, 2004, 19:08:39

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread