[Home] [Design Resources][ Forum Archive ] [ Active Forum ]

 
Share |

Re: shear walls

Stress relieve for 6061T6 al.

From: ------

Comments

I have just designed the tool that will be made from 6061 T6 al. The square tube will have more then a couple of plates, which have to be welded to the tube. The question is Do I have to call out for stress relieving after that? And what spec. might show this process? I could not find anything. I actually found the spec for the heat treatment but I doubt that it is a right way. Thank you.

From: ------

Comments

See my comments below