calculators | Engineering Calculators

Engineering Design Data: Menu - calculators

Engineering Calculators, Engineering equation and Formulas

Pages: << 5 6 7 [8] 9 10 11 >>

A tuning fork is an acoustic resonator in the form of a two-pronged fork with the prongs (tines) formed from a U-shaped bar of elastic metal (usually steel).

Modulus of Resilience Formulae and Calculator

Resilience is the ability of a material to absorb energy when it is deformed elastically, and release that energy upon unloading.

Critical Hall Parameter s parameter Formulae and Calculator

The electrothermal instability (also known as the ionization instability) is a magnetohydrodynamic ( MHD ) instability appearing in magnetized non-thermal plasmas used in MHD converters.

Food Product Cold Storage Data Table

Data table calculator outputs available data on Quick Freeze temperature, Storage temp., Humidity, Specific heat, Latent heat, freezing point, respiration rate.

Hollow vs Solid Shafting Relative Strength and Weight Calculator

This table calculator provides a relative strength and weight of a solid shaft of the same outside diameter.

Pipe Stress Due to Sustained Loads Formulae and Calculator

Pipe Stress Due to Sustained Loads Calculator and Equations per. ASME B31.3 - 2020

Tensile to Hardness Conversion per ISO 18265 Table Calculator

Conversion of hardness-to-hardness or hardness-to-tensile-strength values for unalloyed and low alloy steels and cast steel per. ISO 18265 - 2013. Hardness conversions are no substitute for direct measurements. WARNING - Hardness conversions are no substitute for direct measurements.

Conversion of Hardness-to-Hardness Steels per. ISO 18265 - 2013

Conversion of Hardness-to-Hardness Values for Cold Working Steels per. ISO 18265. Hardness conversions are no substitute for direct measurements.

HVAC Changeover Temperature Calculator

Changeover (Balance) HVAC Temperature Calculator. For all systems using a primary-air system for outdoor air, there is an outdoor temperature (balance temperature) at which secondary cooling is no longer required.

Sure-Fit or Extreme Variability Formulae and Calculator

Sure-Fit or Extreme Variability of Mechanical Tolerances Calculator

Prev Page | Next Page

Pages: << 5 6 7 [8] 9 10 11 >>