View Full Version : Dimensioning Tolerancing GD&T Discussion Forum | GD&T Training


Pages : 1 2 3 [4]

  1. Measuring complex Position features / position to 3 datums
  2. Hole on a symmetry line
  3. Steel plate gauge for 35kg load?
  4. Arrow location on Profile
  5. Profile with MMB modifier -question
  6. Runout on partial diameter
  7. Tolerance zone with position & angle
  8. Standards on Inspection of GD&T parts
  9. CMM Training
  10. Combining Circularity and Straightness into Cylindricity
  11. Hole Pattern Identified as Datum
  12. Correct Tolerance callout
  13. Symmetricity and using hole as Datum
  14. GD&T dispute
  15. True Position Callout with Basic off of Non-Datum?
  16. Bolt circle pattern w.r.t datym
  17. Feature of size
  18. Maximum Material Boundary Condition Interpretation
  19. Cons of zero tolerancing at MMC
  20. Appropiate MMB boundary
  21. Position tolerance exercises
  22. multiple Basic Dimensions vs reference
  23. Formula and Label Classification Questions
  24. Standards & Symbols on the drawing Plastic Moulded parts
  25. Datum Letters
  26. Asme b1.1-2003 unified thread - calculating external minor diameter?
  27. How would you tolerance the channels on this part?
  28. BSC dimension tolerance
  29. Boundaries & there Purpose
  30. Parallelism and Perpendicularity Tolerance in Percentage
  31. Flatness and surface finish spec
  32. Funny profile tolerancing with (U) must match the adjacent recess diameter tolerance!
  33. Slot with Basic location and size tolerance but no Positional
  34. Heat Treat callout
  35. Profile of a line on a drawing?
  36. Position tolerance with parallelism
  37. Slot True Position
  38. Delucidazioni sui controlli GD&T di localizzazione e forma di superficie
  39. two perpendicular axes as DRF?
  40. Hole pattern on narrow edge datum precedence
  41. Auto wheel bearing run out stack up
  42. Basic dim's interpretation