Slider Bush and Shaft Selection for Crank Slider
Hi,
I need someone to point me in the right direction please.
I'm designing a Crank System for a hand held tool. I'ts a simple design with the Crank providing reciprocating motion to a 6mm Diameter Shaft. The Shaft and bushing supporting it will have the following characteristics:
Shaft Stroke: 16mm
Shaft RPM: 2,400
Max Velocity of Shaft: 1.3 m/s
Max Acceleration of Shaft: 220 m/s^2
Lubrication: none/minimum
I need help deciding on a shaft/bushing arrangement that will allow this. specifically:
What type of bushing arrangement should i use?
What type shaft/bushing material should i use?
Are there any off the shelf products for this or should i be looking design myself?
thanks.