Silica in Domestic Water Issue
We have a new domestic system taking bore water for our new house. Have silica being deposited on benches, sinks, basins & baths. Tracked it to hot water via water test below. Supply water flows through particulate filter, coarse salt filter (Kinetico) then another particulate filter before going to hot water cylinder or cold water system. Hot water cylinder also heated by solar system, power and heat pump. Cylinder is Greenglo 500D which is vitreous enamel lined with magnesium anode. Cylinder manufacturer not supplying useful advice.
Anyone have any ideas where the extra silica is coming from in the hot water system?
Anyone know how to remove silica scale from enamel baths, porcelain basins & stainless steel without damage?
[TABLE]
[TR]
[TD]Parameter:
[/TD]
[TD]Before Softener:
[/TD]
[TD]After Softener:
[/TD]
[TD]Hot Tap (after softener):
[/TD]
[/TR]
[TR]
[TD]pH (SU):
[/TD]
[TD]7.3
[/TD]
[TD]8.0
[/TD]
[TD]9.8
[/TD]
[/TR]
[TR]
[TD]Total Dissolved Solids (mg/L):
[/TD]
[TD]110
[/TD]
[TD]120
[/TD]
[TD]240
[/TD]
[/TR]
[TR]
[TD]Alkalinity (mg/L):
[/TD]
[TD]60
[/TD]
[TD]-[/TD]
[TD]-[/TD]
[/TR]
[TR]
[TD]Total Hardness (mg/L):
[/TD]
[TD]80
[/TD]
[TD]<5
[/TD]
[TD]<5
[/TD]
[/TR]
[TR]
[TD]Silica (mg/L):
[/TD]
[TD]14.5
[/TD]
[TD]15.5
[/TD]
[TD]111
[/TD]
[/TR]
[TR]
[TD]Total Iron (mg/L):
[/TD]
[TD]0.05
[/TD]
[TD]0.02
[/TD]
[TD]0.03
[/TD]
[/TR]
[TR]
[TD]Manganese (mg/L):
[/TD]
[TD]<0.01
[/TD]
[TD]0.02
[/TD]
[TD]<0.01
[/TD]
[/TR]
[TR]
[TD]Langelier Index:
[/TD]
[TD]-1.1
[/TD]
[TD]-[/TD]
[TD]-[/TD]
[/TR]
[TR]
[TD]Turbidity (NTU):
[/TD]
[TD]0.26
[/TD]
[TD]0.52
[/TD]
[TD]0.74
[/TD]
[/TR]
[TR]
[TD]Colour (˚H):
[/TD]
[TD]<1
[/TD]
[TD]<1
[/TD]
[TD]<1
[/TD]
[/TR]
[TR]
[TD]%UVT @ 254 nm:
[/TD]
[TD]97.8
[/TD]
[TD]97.1
[/TD]
[TD]77.5
[/TD]
[/TR]
[/TABLE]
The before softener sample was clear with no significant sediment.
The after softener sample was clear with no significant sediment.
The hot tap sample was clear with no significant sediment.