Printable View
Hi,
I want to join two L-angles one across each other with rivets.My problem is while placing one across each other L-angles gets overlapped so here at this zone thickness doubled.i dont want thickness to be doubled so give some suggestions for joining L-angles to the plate with rivets.(Welding is not preffered, only riveting).
Please find the attached file for clear picture.[ATTACH=CONFIG]560[/ATTACH]
Can you weld to the angles before they get to the assembly point?
You could weld small plates to the end of the angles then rivet through the end-plates through the uprights.
Or possibly machine half the thickness off of each leg where they will overlap so they'll sit flush?
Does if have to be angle iron/aluminum? If you make it out of sheet metal you can easily come up with ways to connect the the pieces.