help needed with scissor lift
Hi, I've been trying for some time to construct a scissor lift capable of lift a wheelchair and user to a height of 50cm to enable use of a caravan. I found a web page related to this site which has a formula for calulating force required. It doesn't seem to be correct! The total weight including Platform will be less than 120kgs and the starting angle of the arms is just under 20° which according the the calulator should require 330 kgs force. That wasn't enough to move the lift so I increased the available force to a stage where I now have 600kgs or 6000N acting on the lift and it barely moves. The construction has one arm fixed at the top and all others are free moving, with two 3000N actuators pulling the two lower arms together to raise the Platform (I'll worry about fixing it in place once I can get it lifting). It works ok with about half the working load on it. Should I.... A/ Increase the starting height thereby increasing the arms starting angle , which will make things easier to move. B/ Increase available force C/ Move the actuator to a position where one end is fixed D/ Go back to using a tent. Thanks for all and any advice.