Printable View
Question for you all. I am not sure if the attached is controlling the orientation and location of the two notches at 60deg.
Does the 2X notch position dim & FCF control both the center axes orientations and locations of the notches with this setup?
I appreciate any help I can get on this!
(per ASME 14.5Y 2009)
Yes, the 2x position tolerance as specified does control the orientation and location of the center PLANE of the notch features relative to the DRF A|B|C.
I would have actually put two separate 60 deg basic dimensions (one for each notch) but that's just personal preference.
[QUOTE=Kelly Bramble;17555]Yes, the 2x position tolerance as specified does control the orientation and location of the center PLANE of the notch features relative to the DRF A|B|C.
I would have actually put two separate 60 deg basic dimensions (one for each notch) but that's just personal preference.[/QUOTE]
Perfect! Thank you!