Looking for the correct Standard
Hi all,
New here, but have used this site many many times to gain knowledge.
I have a mechanical drawing under a rev change and under previous revs, parts were removed from the parts list and the FN's were listed as "Obsolete", but remained on the drawing. The drawing in now being reved again and the engineer is redlining to say remove the obsolete lines, but not renumber the parts list, so now I have a drawing they want released the has FN's go sequentially up to sat 5 and the next FN is 17. I know this is because the engineer does not want to have to renumber his drawing. (Worked with them for years and I know how they get)
As the QAE reviewing this, I know I'm going to reject this change, but I cannot find the reference to stand on. I have looked through ASME Y14.100 and ASME Y14.34M but can't find where it would actually say this can or cannot be done.
I really could use some guidance on this one. Hope I posted in the correct area.
Thank you