Search:

Type: Posts; User: Foudzing

Search: Search took 0.00 seconds.

  1. Hi enotyphoon. I am not a graduated engineer...

    Hi enotyphoon.

    I am not a graduated engineer yet, so tread my comments cautiously. But here's my opinion.

    Bolt A: I think you know already know that but I prefer to be sure, this happens if the...
  2. You're basically right. Considering that the...

    You're basically right.

    Considering that the rate of flow is constant, and as the rate of flow is equal to the velocity multiplied by the cross section area (Q = v * A) so when the cross section...
  3. You're welcome, oh and I forgot to tell you: if...

    You're welcome, oh and I forgot to tell you: if you exceed the maximum elasticity pressure, you'll go in plasticity deformation and your material will never go back to it's original state, so that...
  4. If you look for the easiest model I think Hooke's...

    If you look for the easiest model I think Hooke's law can apply: ΔL = (L0 * F) / (S*E)
    ΔL--> deformation, strain
    L0--> sheet thickness
    F--> load
    S--> surface aera
    E--> Young's Modulus of your...
Results 1 to 4 of 4