Search:

Type: Posts; User: YorkshireDave1

Search: Search took 0.00 seconds.

  1. Replies
    19
    Views
    2,129

    I didn't say I wanted to invent a new spline...

    I didn't say I wanted to invent a new spline Kelly. What I said was that I'm 'looking for an element of patentable novelty'. In this instance, using what is already out there in spades reduces my...
  2. Replies
    19
    Views
    2,129

    As I hinted at in my original post, but no one...

    As I hinted at in my original post, but no one seemed to notice, a standard would be fine if I were not looking for an element of patentable novelty...

    JB your direct approach is far from...
  3. Replies
    19
    Views
    2,129

    Thank you very much JB. Very enlightening. The...

    Thank you very much JB. Very enlightening.

    The measure of turque we are seeing is from an instrument running through the whole thing's centre line and is displayed in Nm. Rather than 'pester you',...
  4. Replies
    19
    Views
    2,129

    JBoggs many many thanks. That makes so much sense...

    JBoggs many many thanks. That makes so much sense and is very enlightening.

    We are using a meter placed inline with the centre spindle, so would I be right in presuming the measured force is...
  5. Replies
    19
    Views
    2,129

    OOps

    This image shows how the adapter fits over the spindle
    2492
    This image is a modification and has my question.
    2494
    Sorry posted pre-edited image :bash:
  6. Replies
    19
    Views
    2,129

    Kelly The internal stainless spindle has an OD...

    Kelly

    The internal stainless spindle has an OD of 5.6mm but it has an M3.5 threaded hole in it. The splines on that spindle are just 0.4mm deep in their centre and 1.33mm wide.

    The OD of the...
  7. Replies
    19
    Views
    2,129

    Hi Kelly. Under 10 Newton's. A screw thread on...

    Hi Kelly.
    Under 10 Newton's. A screw thread on the stainless centre fails at 7.1N
    Hope that helps
  8. Replies
    19
    Views
    2,129

    Understanding 'simple' splines - help!

    Hello everyone.

    Unfortunately, I am an 'instinctive' inventor. As such I fully realise just how much I do not know. That said, invariably 'things' work and are reliable.

    2489
    This image is of...
Results 1 to 8 of 8