Search:

Type: Posts; User: gholambaghery222

Search: Search took 0.00 seconds.

  1. Hi adamatavd In my opinion it would be better if...

    Hi adamatavd
    In my opinion it would be better if you draw it in SolidWorks or AutoCAD invertor and then simulate it. In this case you can find out FEA and all other necessary data about your project...
  2. Hi David The harmonic drive has less ration than...

    Hi David
    The harmonic drive has less ration than cycloid gearboxes. When you step on designing and calculation you find the outer gear should be at least two cogs more than the inner gear...
  3. Sorry but I guess you cannot find anything with...

    Sorry but I guess you cannot find anything with the same ratio of cycloid or harmonic gears. On the other hand, you can use hydraulic systems for reduction by employing a hydraulic pump and hydraulic...
  4. Hi jeremykieffer I read your post. In my...

    Hi jeremykieffer
    I read your post. In my opinion, you should use a composition of electronic and hydraulic solutions. let me explain what is in my mind and this is based on my experiences. you can...
  5. Replies
    3
    Views
    234

    Hi Pholoaw send me a sketch of what is in your...

    Hi Pholoaw
    send me a sketch of what is in your mind and then I can simulate it in ANSYS software. so you can have the exact and trustable answer. My question is :are you going to use something like...
  6. Hi It depends of how far do you lift the load...

    Hi
    It depends of how far do you lift the load from the wall. It's so important. and let me know if you can use a steel bar or wire cable for support behind the wall.
  7. did you consider the amount of entropy too? I am...

    did you consider the amount of entropy too? I am not sure if you consider it.
  8. It would be simple. If you make a circle and put...

    It would be simple. If you make a circle and put another circle inside of it with a radius equal to R/2 and join them with gears to provide rotation speed by a rate of 2 to one and select a point on...
  9. Replies
    12
    Views
    3,594

    Hi You can use "mannesmann" tubes in this case...

    Hi
    You can use "mannesmann" tubes in this case you don't need any finishing or removing the weld line inside the tube. However if you want to finish inside the tube I will recommend you to build a...
  10. Replies
    2
    Views
    723

    Hi I have had the same problem a few years ago,...

    Hi
    I have had the same problem a few years ago, as I am an old engineer and I didn't use CAD software and I didn't familiar with those. So, I start with AUTO-CAD but after some days I found...
  11. Replies
    17
    Views
    1,273

    Hi I'm new in this forum but it seems to me you...

    Hi
    I'm new in this forum but it seems to me you cannot find an off-the-shelf part why you don't use planetary gear for reducing the numbers of turn?

    Enable GingerCannot connect to Ginger Check...
Results 1 to 11 of 11