# Search:

Type: Posts; User: gholambaghery222

## Search: Search took 0.00 seconds.

by gholambaghery222
Replies
3
Views
58

### Hi Pholoaw send me a sketch of what is in your...

Hi Pholoaw
send me a sketch of what is in your mind and then I can simulate it in ANSYS software. so you can have the exact and trustable answer. My question is :are you going to use something like...
2. ## Thread: Cantilever Jib Crane mounted to Stud Wall

by gholambaghery222
Replies
3
Views
529

### Hi It depends of how far do you lift the load...

Hi
It depends of how far do you lift the load from the wall. It's so important. and let me know if you can use a steel bar or wire cable for support behind the wall.
3. ## Thread: first law analysis of Rankine Power Cycle Thermal Efficiency Help

by gholambaghery222
Replies
3
Views
1,081

### did you consider the amount of entropy too? I am...

did you consider the amount of entropy too? I am not sure if you consider it.
4. ## Thread: How to design a Linkage let one point go line or a approximate line?

by gholambaghery222
Replies
3
Views
1,173

### It would be simple. If you make a circle and put...

It would be simple. If you make a circle and put another circle inside of it with a radius equal to R/2 and join them with gears to provide rotation speed by a rate of 2 to one and select a point on...
5. ## Thread: Removing inside weld line of a pipe

by gholambaghery222
Replies
12
Views
3,499

### Hi You can use "mannesmann" tubes in this case...

Hi
You can use "mannesmann" tubes in this case you don't need any finishing or removing the weld line inside the tube. However if you want to finish inside the tube I will recommend you to build a...

by gholambaghery222
Replies
2
Views
642

### Hi I have had the same problem a few years ago,...

Hi
I have had the same problem a few years ago, as I am an old engineer and I didn't use CAD software and I didn't familiar with those. So, I start with AUTO-CAD but after some days I found...

by gholambaghery222
Replies
17
Views
1,191

### Hi I'm new in this forum but it seems to me you...

Hi
I'm new in this forum but it seems to me you cannot find an off-the-shelf part why you don't use planetary gear for reducing the numbers of turn?

Enable GingerCannot connect to Ginger Check...
Results 1 to 7 of 7