Search:

Type: Posts; User: adirajck

Search: Search took 0.00 seconds.

  1. Yes, The vertical dimension of holes are not...

    Yes, The vertical dimension of holes are not center. So, the purpose of the centre lines are just to convey the shop people that it is symetric verticaly and horizontaly?
  2. Thanks For the Reply. I have made corrections in...

    Thanks For the Reply. I have made corrections in the diagram as per Your Suggestion. Please check it If i am Correct. It is a #rd Angle Projection.

    2319
  3. Thanks for the Reply, If i remove the...

    Thanks for the Reply,

    If i remove the center-line marking ( 17.5mm ), How will the supplier understand the hole location, If i am not supposed to mark the Hole location from the edge.?

    also,...
  4. Dimension Marking with Center Lines in Engineering Drawings

    Hi,
    I am new to Engg Drawing and confused if I can Mark Dimension with Center Lines in Engineering Drawings like the attached file. Also, Can i add Positional Tolerance without any datum like...
  5. Thank You for Your Valuable Reply. Sorry, i...

    Thank You for Your Valuable Reply.

    Sorry, i didn't mention, I am following ISO Standards. For fits i am referring to ANSI B4.2.

    I've not been in Precision Product Design for long. Many naive...
  6. How to Interpret Geometric Tolerance and Dimensional Tolerance

    Hi,
    I'm confused with the Geometric Tolerance and Dimensional Tolerance. I have read many articles but it had not solved my doubt. I'm confused on how to put tolerance on a shaft and hole with...
Results 1 to 6 of 6