Search:

Type: Posts; User: Semiond

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    720

    Thank you very much for the help. I got all my...

    Thank you very much for the help.
    I got all my questions answered, and I appreciate your effort very much.
  2. Replies
    11
    Views
    720

    Thank you for turning my attention to the...

    Thank you for turning my attention to the resultant datum issue. I suppose that something like the "complex" datum feature (fig. 4-3, illustration g) is a good reference.

    I'm a little confused...
  3. Replies
    11
    Views
    720

    Thank you very much, Kelly. By your advice, I...

    Thank you very much, Kelly.
    By your advice, I reviewed fig. 8-24. The combined control of profile of a surface and position can certainly be relevant, thank you for the reference.
    I'd like to ask...
  4. Replies
    11
    Views
    720

    Thank you very much for the reply, Kelly. I was ...

    Thank you very much for the reply, Kelly.
    I was concerned that since datum feature B symbol is attached to the width dimension given between the fillets, it might not represent the center of the...
  5. Replies
    11
    Views
    720

    Kelly, thank you very much for the reply. In...

    Kelly, thank you very much for the reply.
    In continuation to that, another question if possible: according to ASME Y14.5-2009,
    Is it acceptable to control the taper for position and use it as a...
  6. Replies
    11
    Views
    720

    Feature of size question

    Hello, my question is:
    Can a flat taper feature (consisted of 2 non-parallel faces) be considered a feature of size? The purpose is control that tapered feature with a position tolerance, attaching...
Results 1 to 6 of 6