Search:

Type: Posts; User: brillixa_h06

Search: Search took 0.00 seconds.

  1. I basically use very shallow step-down (0.2mm)...

    I basically use very shallow step-down (0.2mm) for the rough cut and turn the feed-rate up. This sends the aluminum chips flying so there’s less friction and less heat. I do this instead of engaging...
  2. What are the best practices for machining Aluminum?

    Hello I'm new here<br>
    Iím looking for some direction/advise on machining Aluminum parts. What would some best practices be in regards to bit material, feedrate, RPM, etc?<br>Thanks!
Results 1 to 2 of 2