Search:

Type: Posts; User: Kelly Bramble

Search: Search took 0.01 seconds.

  1. Replies
    11
    Views
    1,193

    So now, this is turning into high level training....

    So now, this is turning into high level training. I'm going to cut you off as training and consulting with folks on the internet does not put food on the table.

    Feel free to ask simple questions...
  2. Replies
    11
    Views
    1,193

    A datum surface can be any geometry you can dream...

    A datum surface can be any geometry you can dream up - which is clear to me however the point I intended with Figure 4-29 was that you could find a method that indicates to the surface(s) which you...
  3. Replies
    11
    Views
    1,193

    Figure 4-29 and 4-47 as relative templates,...

    Figure 4-29 and 4-47 as relative templates, identify the two surfaces as single datum entity. This should resolve into an equalizing datum feature as shown in the second referenced figure.

    And,...
  4. Replies
    11
    Views
    1,193

    I'm seeing a very small detail of an end item...

    I'm seeing a very small detail of an end item were I have zero knowledge of end item design intent and functionality. The datums are adequate to define a DRF.

    Should you require the entirety of...
  5. Replies
    11
    Views
    1,193

    Yes... that works though without functional fit,...

    Yes... that works though without functional fit, and form specifications of the actual installation my response is only cursory. As you aware datum B is only two line elements.
  6. Replies
    11
    Views
    1,193

    That would be an Irregular Feature of Size. If...

    That would be an Irregular Feature of Size. If the are surface elements opposite of each other then it is a feature of size.
Results 1 to 6 of 6