Search:

Type: Posts; User: shiloh

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    953

    Tried this. Was able to drop the table base about...

    Tried this. Was able to drop the table base about 1/8 only as the metal mostly shrank back. I'll need to shape this a diferent way or just make a new one. Can stainless be shaped like a car fender?...
  2. Replies
    4
    Views
    953

    The fitting is a brass affair with 1/4npt threads...

    The fitting is a brass affair with 1/4npt threads and a big nut and rubber washer holding into a punched out hole. the hole doesn't have a beaded edge or anything it's just a flat hole. I should also...
  3. Could you use a vessel inside a vessel and use...

    Could you use a vessel inside a vessel and use steam between the outer and inner vessels to create your pressure? Seems that could isolate the inside vessel and provide crushing pressures at whatever...
  4. Replies
    4
    Views
    953

    Stainless steel heat deform on purpose

    I have a stainless water tray that is about 3' square and 2" deep. it has a drain fitting not quite in the middle. the fittings for the drain are about 3/16" thick and when the tray drains it leave a...
  5. Thread: Motor torque

    by shiloh
    Replies
    5
    Views
    1,161

    Thanks. Will speed be a factor? Ill want to run...

    Thanks. Will speed be a factor? Ill want to run that at 200 rpm.
  6. Thread: Motor torque

    by shiloh
    Replies
    5
    Views
    1,161

    Motor torque

    Hi there

    I need to calculate motor speed and reduction on a drive wheel.

    the wheel is 2" diameter and is pulling a wire that is pinched between it and another roller. I'll need 100lbs of pull...
Results 1 to 6 of 6