Search:

Type: Posts; User: matt.schroeder

Search: Search took 0.00 seconds.

  1. To explain the illustration--don't think of this...

    To explain the illustration--don't think of this as my drawing in it's proper dimensioned state, it is for this discussion.

    I've assigned the variable "X" to the right side of the part diameter...
  2. Rethinking...

    Here's what the engineer really wants.

    X is being used as a variable for our discussion purposes, we're not intending to dimension anything this way on a print.


    --Matt

    821
  3. Thank you Kelly. Much appreciated. Not far...

    Thank you Kelly.

    Much appreciated. Not far off what I was recommending to the engineer--flagging with a drawing note and explanation.

    --Matt
  4. That is an application I've never seen, might...

    That is an application I've never seen, might anyone have an example?
    Would it use geotols if so, which?

    Thanks

    --Matt
  5. Is it acceptable to tolerance the same diameter feature with two tolerances?

    I'm being asked to attempt to tolerance the right side of a cylindrical dia. with a +- tolerance of .003 and the left half of the cylindrical feature with a tolerance of -.002 smaller than the right...
Results 1 to 5 of 5