Search:

Type: Posts; User: gs4492

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    3,926

    thanks for the replies. yeh i decided to bite the...

    thanks for the replies. yeh i decided to bite the bullet and go out and buy one of the those pipe benders. I managed to grab one for just over 10 quid. The 90 was easy to do but i had to make do with...
  2. Replies
    3
    Views
    3,926

    whats the best way to bend a pipe like this?

    Hi. I need to bend a 10mm OD aluminium pipe like the attached image. It dosent have to be aluminium but this was all i could find in 10mm
    without having to buy a large coil of pipe. Can someone...
  3. Replies
    4
    Views
    2,219

    i see. yes i only want one. And these would need...

    i see. yes i only want one. And these would need to soldered together i assume. Hmm. ok ill see if i can find someone to do this for me. Thanks for your help :)
  4. Replies
    4
    Views
    2,219

    Anyone know where i can get one of these?

    114

    I need some kind of copper pipe approximately 7" in length reducing down to 1/2" in diameter like in the attached image. Anyone know where i can get hold of something like this? does it have a...
  5. I also noticed that they have a 240v version...

    I also noticed that they have a 240v version http://www.omega.co.uk/ppt/pptsc.asp?ref=FGR&flag=1

    :)
  6. hmmm. that looks very interesting. My intentions...

    hmmm. that looks very interesting. My intentions were similar to yours, only with a type of bidet device. I did a quick bit of googling around and i saw this one as well...
  7. looking for economical and very small water heating device...

    Hi. You will have to excuse my ignorance...

    Basically, i am looking for a water tank including immersion heater, thermostat etc.

    1. The tank only needs to approximately 1/8 of a gallon (approx...
  8. Replies
    7
    Views
    4,870

    Thank you both for the advice. Yes that was an...

    Thank you both for the advice. Yes that was an interesting article and something i need to think about. My plan was to have the prototype built in England and have it fully tested. If things go well...
  9. Replies
    7
    Views
    4,870

    Hi. Thanks Well i was thinking Cambodia...

    Hi. Thanks

    Well i was thinking Cambodia because my plan was to move back out there in the near future. I thought it might help if i could have direct communication with the manufacturer. That said...
  10. Replies
    7
    Views
    4,870

    Manufacturing in Cambodia?

    Hi. I am currently in the process of having a product developed and i am looking into outsourcing the manufacturing. The whole thing is very new to me so i was wandering i could get some general...
Results 1 to 10 of 10