Search:

Type: Posts; User: gholambaghery222

Search: Search took 0.00 seconds.

  1. Hi It depends of how far do you lift the load...

    Hi
    It depends of how far do you lift the load from the wall. It's so important. and let me know if you can use a steel bar or wire cable for support behind the wall.
  2. did you consider the amount of entropy too? I am...

    did you consider the amount of entropy too? I am not sure if you consider it.
  3. It would be simple. If you make a circle and put...

    It would be simple. If you make a circle and put another circle inside of it with a radius equal to R/2 and join them with gears to provide rotation speed by a rate of 2 to one and select a point on...
  4. Replies
    12
    Views
    3,471

    Hi You can use "mannesmann" tubes in this case...

    Hi
    You can use "mannesmann" tubes in this case you don't need any finishing or removing the weld line inside the tube. However if you want to finish inside the tube I will recommend you to build a...
  5. Replies
    2
    Views
    626

    Hi I have had the same problem a few years ago,...

    Hi
    I have had the same problem a few years ago, as I am an old engineer and I didn't use CAD software and I didn't familiar with those. So, I start with AUTO-CAD but after some days I found...
  6. Replies
    17
    Views
    1,159

    Hi I'm new in this forum but it seems to me you...

    Hi
    I'm new in this forum but it seems to me you cannot find an off-the-shelf part why you don't use planetary gear for reducing the numbers of turn?

    Enable GingerCannot connect to Ginger Check...
Results 1 to 6 of 6