Search:

Type: Posts; User: t_u_k_2k3

Search: Search took 0.00 seconds.

  1. The design intent is to control the location of...

    The design intent is to control the location of the square feature with respect to the horizontal datum (common to all 4 square features) and the vertical datum (individual datum for each square...
  2. People are thinking that the true position will...

    People are thinking that the true position will be applied to both vertical and horizontal direction because the feature being controlled by the true position has the square symbol. I am trying to...
  3. The drawing in your reply is the original...

    The drawing in your reply is the original drawing, and there is no confusion in that. When a new part number was created due to material change with all geometrical features remain the same, the...
  4. Sorry if the engineering drawing is hard to read...

    Sorry if the engineering drawing is hard to read and incomplete, I cannot upload the entire drawing for a reason and I have to remove the dimensions. The 4 square hole features as shown on the green...
  5. My own interpretation is that the symbol is...

    My own interpretation is that the <CF> symbol is wrongly used in this case. How can you consider the square hole features as a single feature? With regards to the true position without the diameter...
  6. GD&T Position Tolerance and continuous Feature symbol application

    Is it correct to use the continuous feature symbol in this case? and how to you interpret the true position tolerance? Is it applied to both axis because of the 'square symbol' or does it keep its...
Results 1 to 6 of 6