Search:

Type: Posts; User: YorkshireDave

Search: Search took 0.00 seconds.

  1. Hi Hudson Thank you so much. I have managed...

    Hi Hudson

    Thank you so much.

    I have managed to find DIN 5481 which kinda feels right. From further reading I understand one calculates the pin dia as it must touch at some 'magical' point (or...
  2. Many thanks for those. I had found some not...

    Many thanks for those. I had found some not others.

    Confession time. I can't make head nor tail of it all. From what I can see, that seems to be for 'proper' splines, splines designed to transmit...
  3. 'simple' spline calculation help pls

    Would someone be kind enough to point me to where I might be able to learn how to specify some simple splines?

    Let me expand. I need to create a series of spindles for tap (faucet) cartridges (the...
  4. Replies
    8
    Views
    2,190

    It's not complicated. However one part must be...

    It's not complicated. However one part must be changeable. Hence the join.
  5. There is one other difference to consider too....

    There is one other difference to consider too. Switchgear is designed to be regularly operated whereas circuit breakers are not.
  6. Replies
    8
    Views
    2,190

    I'm not doing anything 'special' I agree. Tap in...

    I'm not doing anything 'special' I agree. Tap in this instance is your faucet, so the forces involved are turning and typical of those involved in the daily use of a faucet.

    As I'm looking to...
  7. Replies
    8
    Views
    2,190

    Thank you peeps. COD. Hmm. I have to be...

    Thank you peeps.

    COD. Hmm. I have to be careful describing the use due to wanting to protect what I'm doing. Suffice to say, the side with the splines on will have a tap head attached and the...
  8. Replies
    8
    Views
    2,190

    Joining two brass components - advice?

    I have a 8mm long, 10mm round brass shaft (A) to which I need to join a 7.7mm splined shaft (B) - as strongly as possible.

    Thus far I have tried:

    Threading shaft (A) to 5mm (fine 0.5mm),...
  9. Replies
    4
    Views
    4,081

    Try changing the design so the surface the lamps...

    Try changing the design so the surface the lamps sit on is curved. That will give you better spread ad negate the narrow beam of output of most std LEDs. Google is your friend as there are now many...
Results 1 to 9 of 9