Search:

Type: Posts; User: sickwayne77

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    1,917

    I feel like I need to clarify a couple of things...

    I feel like I need to clarify a couple of things on that post. I am only referring to small vehicle applications, like scooters, go-karts, and electric lawn mowers. I have a 1/3 HP motor and a...
  2. Replies
    3
    Views
    1,917

    Motor size VS RPM VS power

    Hi all, I have a real quick question; should I use a cheaper, smaller, LIGHTER, higher rpm motor from the RC hobby world or a larger, heavier, more expensive motor? Here are the details:

    For some...
  3. I made the case some time back to have the setup...

    I made the case some time back to have the setup analyzed for a handful specific stress points, I'll make that case again. I had a statics course quite a while back and taught myself strengths...
  4. 500 dimensioned sketch Here is everything I...

    500 dimensioned sketch

    Here is everything I have, basically. I attempted to set up a free-body diagram and if there were all hinged supports I would be able to, but the welded supports are more...
  5. Pinkerton, there are several point loads that I...

    Pinkerton, there are several point loads that I used to get a sumation of moments. I believe you have helped me with my main question. If it were not the entire cross section that counts, but just...
  6. 502 Thank you again. You can see in the...

    502

    Thank you again. You can see in the sketch, it is a tube welded to a base structure at two points. The moment about point A is 19,500 lbXin. I just wanted to make sure I used the equation...
  7. Beam Stress and the Questions I have about it

    Hi, new to the forum, I have a couple questions about stress in a beam that I am currently working with.

    The beam is a length of 2"X2"X3/16" square tubing. I have an equation for normal stress...
Results 1 to 7 of 7