Search:

Type: Posts; User: jlenth

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    1,941

    Gd&t for a radial hole

    I have an application where a hole drilled radially into a tube needs to be positioned relative to another hole drilled radially into the tube. The radial offset of the two holes are critical,...
  2. Replies
    7
    Views
    2,258

    Kelly, Please disregard my above questions,...

    Kelly,

    Please disregard my above questions, due to lack of sleep my brain hasn't been firing on all cylinders. Thanks for all help
  3. Replies
    7
    Views
    2,258

    View Post

    Kelly,

    Itís ďimpliedĒ that when circular runout is called out on a drawing that the circular runout is theoretically applied to an infinite number of 2-D cross sectional planes along the...
  4. Replies
    7
    Views
    2,258

    Kelly, Hopefully you can provide your...

    Kelly,


    Hopefully you can provide your insight on one last question, total runout. Iíve seen other posts on this same topic, but havenít seen anything that came out and specifically said...
  5. Replies
    7
    Views
    2,258

    Kelly, Thanks for the response and your...

    Kelly,


    Thanks for the response and your input, I appreciate it. Responses to your comments below and I have another question that popped up in my mind as I get closer to finishing with...
  6. Replies
    7
    Views
    2,258

    Rookie needing some help with GD&T questions

    Hoping I can get some help on some questions that I canít quite find a clear answer for in either the ASME Y14.5 standard or already on this site (not the most experienced with GD&T yet).
    ...
Results 1 to 6 of 6