Search:

Type: Posts; User: Zach0350

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    3,976

    I swore I posted that days ago. Let me know if...

    I swore I posted that days ago. Let me know if this helps.
  2. Replies
    3
    Views
    3,976

    I would simplify this simulation with just the...

    I would simplify this simulation with just the carbiner. Use a sketch to split the face (parting line) at the assumed contact area on both sides. I would then set the top face as a fixed surface and...
  3. Replies
    11
    Views
    2,955

    Awesome video Kelly. Still addressing his...

    Awesome video Kelly.

    Still addressing his question and questions of my own, how do we define an "area" on one side to an "area" on the opposite side? I also have castings that have partially...
  4. Replies
    11
    Views
    2,955

    1057

    1057
  5. Replies
    11
    Views
    2,955

    I believe he is trying to ensure one defined area...

    I believe he is trying to ensure one defined area on the side of the box is parallel to the opposite side only in the defined area. Not sure if he needs 2 datums for this callout. I'm not too...
  6. Replies
    3
    Views
    1,840

    I love the quick reply box.. makes everyone feel...

    I love the quick reply box.. makes everyone feel incapable of typing.

    I will look into my Eng Mech books.
  7. Replies
    8
    Views
    10,619

    you can set sub-assemblies to "flexible" within...

    you can set sub-assemblies to "flexible" within other sub-assemblies.
    Like this:

    Assembly
    >Sub-Assembly - FLEXIBLE
    >Sub-Sub-Assembly - Also set to flexible.
  8. Replies
    9
    Views
    5,342

    My university dropped its Inventor licenses and...

    My university dropped its Inventor licenses and were working to drop their ProE as well. The other coursework I had used CATIA which was sponsored by Boeing. (I assume it is big in the Aerospace...
  9. Replies
    2
    Views
    3,096

    We often do not renumber our upper level drawings...

    We often do not renumber our upper level drawings (layouts for trackwork, etc.). This is to ensure our service manuals and field copies of drawings (even on outdate revisions) will have similar...
  10. The "upper and lower pin" picture I would weld...

    The "upper and lower pin" picture I would weld tube/pipe to a bar.
  11. You likely will not be able to mill a sharp...

    You likely will not be able to mill a sharp inside corner on the fulcrum pin as you have it modeled. The inside corners should be filleted to produce it by this method. Otherwise you could cut it...
Results 1 to 11 of 11