Results 1 to 2 of 2

Thread: standars for drawings

  1. #1
    Senior Engineer
    Join Date
    Apr 2011
    Location
    Monclova, Coahuila, Mexico
    Posts
    39

    standars for drawings

    ipt>
    talking about drawings is there any standar where can find if it is correct my skill since I have read machinerys handbook and can not to find it in this case what I need to know if is there standar that shown when a dimension on drawing is inscribed on a square I must be follow the machining tolerances per drawing.

  2. #2
    Technical Fellow
    Join Date
    Feb 2011
    Posts
    1,043
    You can do some searching on this Drawing and Tolerancing Standards ...

    ASME y14.5m

    BUT, whatever it is on the drawing MUST be followed otherwise you will have finished parts rejected. If you can't achieve something on the drawing then you need to discuss it with the Client and have them revise the drawing if possible. They have defined things in the drawing for a reason that is important to the overall assembly of the finished component. It may not seem important to you on that one part.
    Last edited by PinkertonD; 08-25-2011 at 09:52 AM. Reason: Damned Dyslexia

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •