Results 1 to 2 of 2

Thread: Old Cleco crane alignment

  1. #1
    Associate Engineer
    Join Date
    Dec 2015
    Posts
    1

    Old Cleco crane alignment

    Hello my name is Dave a the reason for this post is after a project that i was involved with which was to replace drive wheels and traction motors on these cranes we have had a problem with tracking. i did believe we would have tracking problems as we was changing everything at once so didn't have any past reference to go on. I sense been struggling to line these cranes back up using a laser level to which they are better for about a week then get extremely noisy again. If anyone has any past experience with narrow aisle cranes (these are on rails on the floor i think they are condors but not 100% on that) i can post some picks at a later date
    many thanks dave
    Last edited by Kelly Bramble; 12-30-2015 at 09:09 AM.

  2. #2
    Banned
    Join Date
    Dec 2018
    Location
    India
    Posts
    1
    Nice Post!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •