Results 1 to 4 of 4

Thread: Need help on how to PROPERLY inspect this dimension

  1. #1
    Associate Engineer
    Join Date
    Apr 2016
    Posts
    2

    Need help on how to PROPERLY inspect this dimension

    The .875 Radius is in print, but the location from the center of the square to the .875 R is out of tolerance by a couple thousandths. Is this calling out location or radius? And how would you check it?
    Attached Images Attached Images

  2. #2
    Administrator Kelly Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,259
    Looks antique... What standard is the engineering drawing specified to?
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

  3. #3
    Associate Engineer
    Join Date
    Apr 2016
    Posts
    2
    70s haha... MIL-STD-100

  4. #4
    Administrator Kelly Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,259
    Looks like the top radius feature center point is located relative to the center of the square feature and built in size to R .875 +0, -.010
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •