Results 1 to 1 of 1

Thread: Normal conditions for WET gas

  1. #1
    cardrunner
    Guest

    Normal conditions for WET gas

    Hi everybody, need you advice! So the situation: Customer need a gas compressor, and gas is a hydrocarbon mix (methane+ethane ..etc) + water. The water dew point is below inlet/discharge temperature of the gas so no water drops as liquid.

    Customer indicated the gas flow as 3000 nm3/h. and indicated nm3/h is @ 0 degC, 1,013 bara, 0% relative humidity.
    How can it be? How can i select the compressor, using the flow data when there will always be some amount of water inside the gas?

    Thank you!
    Last edited by Kelly_Bramble; 07-26-2016 at 07:24 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •