Results 1 to 3 of 3

Thread: Surveying - Understanding How Face 1 and Face 2 Value Are Observed

  1. #1
    Associate Engineer
    Join Date
    Sep 2012
    Posts
    5

    Surveying - Understanding How Face 1 and Face 2 Value Are Observed

    Hello all

    I have trying to learn how to survey. I am not an engineer or work in surveying however I have access to a Trimble S8 Total station and i am trying to learn how to use it off my own back.

    I was wondering if anyone out there in the community could explain how Face 1 and Face 2 angles are observed using a total station or theodolite for that matter.

    Below is a diagram of how I think face 1 and face 2 observations are recorded.


    Is This Correct.jpg

    The picture on the left is an angle measured to target 1 in the forward face (face 1), in this case it measures 60 Degrees - I am happy with this.

    The picture on the right shows the telescope reversed, so the instrument is now in the reverse face, face 2 (Blue line). The angle the instrument reads is still 60 degrees, but is now read from the opposite side of the circle. The instrument then sights back to target 1 (clockwise) but continues to increment the angle from 60 degrees.

    Have I nailed it or shall I get my head examined?

    Can someone confirm?

    Thank you.

  2. #2
    Administrator Kelly Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    1,955
    Here's a couple of training videos on the use of a Surveying Theodolite.

    Operating a theodolite Part 1

    Operating a theodolite Part 2
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

  3. #3
    Associate Engineer
    Join Date
    Aug 2017
    Posts
    1
    Thanks Kelly...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •