Results 1 to 2 of 2

Thread: Deflection and Stress of arm with an angle

  1. #1
    Enchantedhorses
    Guest

    Deflection and Stress of arm with an angle

    I'm trying to use a piece of sheet metal for a project that has an angle in it and want to calculate the stresses and deflection to see how thick the metal should be. I want to calculate at various loads. Currently the design is shaped kind of like a crane, fixed at the bottom, goes straight up 5" then has a 30 degree bend for 10" then straight up for 3". Load is at the top of the arm straight down. I just need help setting up how to calculate.

    Thanks for the help!

  2. #2
    Principle Engineer Cragyon's Avatar
    Join Date
    Feb 2013
    Location
    Newark, NJ
    Posts
    299
    If your a premium member use the online statics modeler.. https://www.engineersedge.com/calcul...d-modeling.htm

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •