Results 1 to 2 of 2

Thread: How a non uniform force, converted to an equivalent point force acts on a surface.

  1. #1

    How a non uniform force, converted to an equivalent point force acts on a surface.

    Hello all

    I am trying to understand how a non uniform force, converted to an equivalent point force acts on an object.

    I was hoping I could get the communities opinion on the following sketch I have made:-


    In Diagram A have a non uniform force that is being applied to my shape.
    The centre of mass & centroid are the same location as the density of the material is uniform.


    as1.jpg


    In Diagram B I have calculated the X,Y,Z position of the force distribution shown in blue.
    I now have 2 x centroids, one for my shape and one for my force distribution.

    as2.png

    In Diagram C I have projected the centroid of my force distribution onto my shape shown in yellow.

    as3.jpg

    If I converted my non uniform distributed load into an equivalent point load then would it be correct to say that the point force would act at the projected centroid (yellow) and not the centroid of my shape.

    Is this correct?

  2. #2
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,611
    Depends on how the object is supported relative to the applied force.

    Is the object/shape statically located and how?
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •