Results 1 to 3 of 3

Thread: Calculating Youngs Modulus

  1. #1

    Calculating Youngs Modulus

    Hello all

    I wondering anyone could help me with the following:-

    When plotting a stress strain curve for a material I believe it is normal practice to express Strain in %.

    My question would be that when calculating Youngs modulus is it typical to use Strain in units of %?

    I if was to plot my stress strain curve then my equations would be:-

    Stress = Force / Area
    Strain = (Change in Length / Original Length)*100 (Strain is now in units of %)

    If I wanted to calculate Youngs Modulus then my equation would be either:-

    Youngs Modulus = (Force/Area) / [(Change in Length / Original Length)*100]

    Or

    Youngs Modulus = (Force/Area) / (Change in Length / Original Length)

    Can anyone help?

    Thanks

  2. #2
    Principle Engineer Cragyon's Avatar
    Join Date
    Feb 2013
    Location
    Newark, NJ
    Posts
    265
    Every stress-strain plot I've seen was reported in actual units. I don't think the strain is being report as a % but being converted into a multiple for ease of reading the plot.

    A note would accompany the plot indicating strain units x 100

  3. #3
    Administrator Kelly Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,366
    Engineers Edge does have a Stress-Strain curve Approximation calculator based on the Ramburg-Osgood equations.

    Enter known data and the curve data points are calculated plotted and tabulated.

    See: https://www.engineersedge.com/calcul...urve_15438.htm

    Stress-Strain.png
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •