Results 1 to 5 of 5

Thread: Understanding moment and dynamic loading calculations

  1. #1
    Associate Engineer
    Join Date
    Jul 2021
    Posts
    2

    Understanding moment and dynamic loading calculations

    Hello.

    I am building a custom motorcyle hitch carrier for myself for the back of an RV and I am trying to determine the weight bearing capacity of the square tubing to find out if I have enough support to handle the load dynamically.

    I know there are a multitude of online calculators out there, but I am not positive the calculations are correct.

    Basic information

    Moment is 26" from hitch receiver
    Square tube is 2" x 2" x .25" thick walls
    Hitch receiver is a class 4 with a tongue rating of 1000 lbs
    Platform is a converted I-Beam that will be holding a motorcycle - total weight is approximately 900 lbs

    Additional circular tubing has been welded to the I-Beam and is inserted into the C-Channel of the vehicle frame (not currently bolted, but supported by the c-channel).

    I am interested in finding out the proper formula to fully understand the load limits of this contraption.

    Thanks for your help.
    Attached Images Attached Images

  2. #2
    Principle Engineer Cragyon's Avatar
    Join Date
    Feb 2013
    Location
    Newark, NJ
    Posts
    279
    First, to do the statics calculations one will need a free body diagram. This should be provided by you...

  3. #3
    Associate Engineer
    Join Date
    Jul 2021
    Posts
    2
    Thanks Cragyon for your reply. I am working on creating a free body diagram. If you have any tips (or links) for creating one, let me know. I believe I have worked out most of it, but any insight would be helpful. Thanks.

  4. #4
    Administrator Kelly Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,433
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

  5. #5
    Engineer
    Join Date
    Apr 2021
    Location
    Germany
    Posts
    11
    Hi adamatavd
    In my opinion it would be better if you draw it in SolidWorks or AutoCAD invertor and then simulate it. In this case you can find out FEA and all other necessary data about your project faster than handy calculation. Enable GingerCannot connect to Ginger Check your internet connection
    or reload the browserDisable in this text fieldRephraseRephrase current sentenceEdit in Ginger×

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •