Results 1 to 2 of 2

Thread: Spur Gear DP Nube Question

  1. #1
    Associate Engineer
    Join Date
    Nov 2021
    Posts
    1

    Spur Gear DP Nube Question

    Hey All
    Firstly I would like to say Thank You to the creators of this site for allowing free use of the gear generator.

    My issue is that the project I am working on requires a gear set of 112Teeth & 14Teeth gears. I can buy the gears I need in metric ie Module 1, but it's really expensive; around $1000 AUD for the set (including 8 of the smaller gears.)

    I see a lot of 112T 64DP gears out there which are really cheap (starting at $10), but I cannot find 14T 64DP gears anywhere. Surely it's not impossible to make them as it can be made in metric/module.

    Is there something I am not understanding in the DP range?

    Where can I find a 14Teeth Gear to suit a 112 Teeth 64DP gear?

    Cheers for your time.

  2. #2
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,611
    14T 64DP is a very small pinion gear and availability is driven by demand and manufacturability as well.

    I suggest that you redesign for the same gear ratio using a pinion that is clearly available from multiple suppliers.
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •