Results 1 to 5 of 5

Thread: Composite called out

  1. #1
    Associate Engineer
    Join Date
    Apr 2012
    Posts
    3

    Composite called out

    can you help interpret this?
    Attached Files Attached Files

  2. #2
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,611
    You have six cylindrical features than can be manufactured as small as diameter.gif 17.2 and as large as diameter.gif 17.6 and are identified as "A".

    This is called a Composite Feature Control Frame:

    composite.gif

    The upper horizontal frame:

    upper.gif

    Specifies that the position tolerance of the as-manufactured cylindrical feature derived axis must fall within a cylindrical tolerance boundary equal to diameter.gif 1.4 when the cylindrical feature is manufactured at mmc.gif or MMC (Maximum Materials Condition) that is oriented and located relative to Datum's "A", "D", and "E" when "E" is at mmc.gif
    Attached Images Attached Images

  3. #3
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,611
    The lower horizontal frame

    lower.gif

    Specifies that the position tolerance of the as-manufactured cylindrical features derived axis must fall within a cylindrical tolerance boundary equal to diameter.gif 0.2 when the feature of size is manufactured at MMC and is oriented to Datum "A".

  4. #4
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,611
    Oh, and you might want to check out the book:

    Geometric Boundaries, II

    http://www.engineersedge.com/catalog...roducts_id/124

  5. #5
    Associate Engineer
    Join Date
    Apr 2012
    Posts
    3
    Thank much. this is so helpful!!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •