Add SEO Directory Listing | Advertising Information | Contact

Category: Professional Training

Visit Company Website:
Fundamentals of GD&T Online Training, ASME Y14.5 - 2009, 4.0 PDH






Description: Online certificate training program for the Fundamentals of ASME Y14.5-2009, Geometric Dimensioning and Tolerancing (GD&T).

Online certificate training program for the Fundamentals of ASME Y14.5-2009, Geometric Dimensioning and Tolerancing (GD&T).

This training module will be available for 45 days after payment has been received.

Professional Development Hours (PDH) earned = 4.0 hours (Takes approximately 4 hours to complete).

This is an entry level training program and is best for those whom need an introduction to the concepts on dimensioning and tolerancing per. ASME Y14.5 - 2009, Geometric Dimensioning and Tolerancing.

The program is divided up into nine separate training modules and one final test module. Training modules are presented in a Power Point fomat with voice narration. Training pace is controlled by learner. Each training module concludes with a short quiz. The individual training modules will take between 10 and 25 minutes and include:

  • Introduction and rules
  • Limit Tolerances
  • Datums
  • Feature Control Frame
  • Form Tolerances
  • Orientation Tolerances
  • Location Tolerances
  • Profile Tolerances
  • Runout Tolerances
  • Final Knowledge Test (required for certificate of completion)

One must receive an 80% correct or greater on all training modules quiz’s, as well as the final knowledge test to receive a Certificate of Completion.

Contribute Article
Spider Optimizer

© Copyright 2000 - 2017, by Engineers Edge, LLC www.engineersedge.com
All rights reserved
Disclaimer | Feedback | Advertising | Contact