Engineering Design Data: Menu - hardware

 
ANSI ISO Engineering Hardware
Prev Page | Next Page

Pages: << 9 10 11 [12] 13 14

Class 5 Interference-Fit Threads ANSI/ASME B1.12
External Thread Dimensions for Class 5 Interference-Fit Threads ANSI/ASME B1.12-1987 (R1998) design data chart. Rolled Threads for studs.
Minimum Threads Protruding Beyond Nut
A minimum thread protrusion length is given to ensure that all the threads are engaged. This is required to ensure a full-strength fastener. Equipment component drawings should specify the type, length, and size of bolt, stud, bolt-stud, etc. to be used to obtain the proper thread protrusion.
Centrifugal Capacity Retaining Snap Rings
Centrifugal Capacity Retaining Snap Rings is determined on whether the ring remains seated on the groove bottom.
Metric Threads ISO 724
ISO 724 - ISO general-purpose metric screw threads - Basic dimensions (DIN 13), the standard in Europe, is recognizable by its cylindrical outer and inner diameter and its precise outer diameter in millimeters.
AGMA ASA Keyway and Bores Design Data
AGMA ASA Keyway and Bores Design Data including dimension and tolerances.
Self Tapping Screw Pull-Out and Torque Calculator
Self Tapping Screw Pull-Out and Torque Calculator and Equations
Machine Dowel Pins Chart ANSI ASME
The following chart is of Machine Dowel Pins Chart per. ANSI ASME B18.8.2 ANSI ground machine dowel pins (hardened) are furnished in two diameter series: Standard Series having basic diameters 0.0002 inch over the nominal diameter, intended for initial installations; and Oversize Series having basic diameters 0.001 inch over the nominal diameter, intended for replacement use.
Screw Types Guide
This is an illustration guide to the application of Screws.
Specialty Screw Types
This is an illustration guide to the application of specialty screws.
Washer Hardware Guide
This is an illustration guide to the application of washers for designers and engineers.
Prev Page | Next Page

Pages: << 9 10 11 [12] 13 14

© Copyright 2000 - 2021, by Engineers Edge, LLC All rights reserved.
Disclaimer