Engineering Design Data: Menu - instrumentation

 
Instrumentation and Electronics
  • capacitance discharge

  • coil inductance calculator

  • series parallel led

  • voltage drop calculator

  • Wheatstone bridge

  • Prev Page

    Pages: 1 [2]

    Op-Amp Gain Design Equation and Calculator
    These calculators will determine the Gain and output voltage for both a Non-Inverting Op-Amp and an Inverting Op-Amp.
    Zener Diode and Resistor Voltage Regulator Design Calculator
    This calculator will determine the various design parameters for a zener diode resistor voltage regulator. Zener Diodes can be used to produce a stabilised voltage output with low ripple under varying load current conditions.
    Zener Diode, Power Transister on Heat Sink Calculator
    This calculator will determine the variouos design parameters of a Zener Diode, Power Transister on Heat SInk power regulator.
    555 IC Timer Monostable and Astable Design Calculator
    555 IC Timer Monostable and Astable Design Calculator. The 555 timer IC integrated circuit is the first and still one f the most popular IC timer chips in use. This timer IC operates as a one-shot timer or as n astable multivibrator. The 556 IC is a two 55 circuit chip.
    Schmitt Trigger Equations and Calculator
    The following equation and calculator gives values for Schmitt Trigger and an Inverting Schmitt Trigger. A Schmitt trigger is a comparator circuit with hysteresis, implemented by applying positive feedback to the noninverting input of a comparator or differential amplifier.
    Potentiometer Equation and Calculator
    otentiometer Equation and Calculator. A potentiometer or a resistor a pot, is a three-terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider. If only two terminals are used, one end and the wiper, it acts as a variable resistor or rheostat.
    Resistors in Parallel Equation and Calculator
    Resistors in Parallel Equation and Calculator. If two or more components are connected in parallel they have the same potential difference voltage across their ends.
    Ohms Law Equation and Calculator
    Equation and Calculator Ohms Law. Ohm's law states that the current through a conductor between two points is directly proportional to the potential difference across the two points.
    Prev Page

    Pages: 1 [2]

    © Copyright 2000 - 2017, by Engineers Edge, LLC All rights reserved.
    Disclaimer