|
PRESSURE SEALS | |||
Post Reply |
Mechanical Engineering Forum |
Posted by: yangtao ® 07/20/2010, 05:36:28 Author Profile eMail author Edit |
O-ring seal for pressure and its hardness and whether the ring. Under normal circumstances, 70 ° Shore hardness O-rings
to use pressure not higher than 16Mpa, higher than the pressure 16Mpa, should use the hardness of 90 Shore hardness of the O-ring. A ring, the pressure higher. O-ring seal for a fixed time, working pressure up to 100MPa, for the rotating seal, the pressure of not more than 15MPa, circular velocity should not exceed 2 m / s, for reciprocating linear motion sealed, the pressure up to 70MP . Hardness testing device generally 70 O-ring plus ring case 31.5MPa, use the higher pressure to increase hardness, but it will affect the following performance. The key look is the dynamic seal or a static sealing and static sealing pressure with the self- tight structure, 100MPa No problem; dynamic seal using modular sealed! Modified by administrator at Tue, Jul 20, 2010, 08:36:41 |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | Previous | Next | |
|
||||
Replies to this message |
: PRESSURE SEALS | |||
: PRESSURE SEALS -- yangtao |
Post Reply |
Top of thread |
Mechanical Engineering Forum |
Posted by: Kelly Bramble ® 07/20/2010, 08:37:27 Author Profile eMail author Edit |
Is there a question with this? |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | Previous | Next | |
: : PRESSURE SEALS | |||
: : PRESSURE SEALS -- Kelly Bramble |
Post Reply |
Top of thread |
Mechanical Engineering Forum |
Posted by: linuxpenguin ® 01/31/2011, 08:31:20 Author Profile eMail author Edit |
Wish this dude spoke english. Maybe we could assist him :D |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | Previous | | |
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer