Re: True Position


[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Jacek A. Palinski (208.51.233.194) on January 15, 2003 at 16:37:21:

In Reply to: True Position posted by Mark on January 15, 2003 at 13:38:33:

: I am looking for the equation for calculating the true position of a hole. I have a calculator that does it for me automatically however I would like to know the formula for it.

Mark,

The formula is:

z = 2 x sqrt (delta x^2 + delta y^2)

where delta x is the horizontal difference between horizontal basic dimension and what you measured, and delta y is vertical difference in vertical basic dimension and the result of your measurement.

Jacek



Follow Ups:



Post a Followup

Subject: Re: Re: True Position

Comments:


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer