Membership Services

Re: .jpg file into a .dwg file

[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Johnny Mac (152.163.188.165) on April 18, 2003 at 04:17:22:

In Reply to: .jpg file into a .dwg file posted by Armando on May 21, 2002 at 13:58:43:

I have done it but it takes some effort.
You bring it into paint and select all and copy it to your clip board. Then you go into AutoCad and trace over the top of the main lines. When your done delete the jpg and you'll have it. It's the only thing I've found so far.

Follow Ups:

Post a Followup

Subject: Re: Re: .jpg file into a .dwg file

Comments:
: I have done it but it takes some effort. : You bring it into paint and select all and copy it to your clip board. Then you go into AutoCad and trace over the top of the main lines. When your done delete the jpg and you'll have it. It's the only thing I've found so far.

[ Home ][ Forum Archive ] [ Active Engineering Forum ]