Share |

Re: Re: nylatron machineability


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Sam Webster on March 27, 2002 at 15:22:51:

In Reply to: Re: nylatron machineability posted bySam Webster on March 26, 2002 at 13:56:30:

I thought about this some more and I think the fastest thing to do would be to blank off the parts on the lathe then threadmill the I.D. thread. Should be no more stringy chip problem.
Threadmills can be expensive but they can go very fast on a decent CNC mill. Also they create very small chips.




Follow Ups



< "> Subject: Re: Re: Re: nylatron machineability

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer